BMW 3 of the E46 series

since 1998 release

Repair and operation of the car


BMW 3 of the E46 series
+ BMW 3 Cars (E46)
+ Current leaving and service
+ Engine
+ Cooling systems, heating
+ Power supply systems, injection and release
+ Electric equipment of the engine
+ RKPP and transmission line
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
- Body
   General information and security measures
   + Leaving and repair of damages of a body
   + External elements of a body
   - Internal elements of a body
      Removal and installation of forward peaks of the dashboard
      Removal and installation of facing forward parts of the region of feet
      Removal and installation of the left ware box
      Removal and installation of the right ware box
      Removal and installation of the central console
      Removal and installation of the central armrest
      Removal and installation of a pocket of the console of switches
      Removal and installation of the console of switches
      Removal and installation of the electric motor of the drive of the movable panel of a roof
      Removal and installation of a mirror of an interior
      Interior mirror with automatic blackout
      Removal and installation of lateral facing of a luggage carrier
      Removal and installation of facing of the back panel
      Removal and installation of facing of a trunk lid
      Removal and installation of a head restraint of a forward seat
      Natyazhitel of a seat belt. Main data and security measures
      Removal and installation of a forward seat
      Removal and installation of a back seat
      Removal and installation of nozzles of windscreen washer
      Adjustment of nozzles of windscreen washer
      Removal, installation and check of nozzles of a faroomyvatel
      Removal and installation of levers of a screen wiper
      Removal and installation of the tank/pump of a washer
+ Onboard electric equipment
+ Schemes of electric equipment


Removal, installation and check of nozzles of a faroomyvatel

 REMOVAL

1 Take out a nozzle-1-by means of a plastic wedge-2-of the shutter of a headlight and extend it against the stop.

At removal of a nozzle water therefore cover a nozzle with a rag follows and substitute the corresponding capacity. If necessary insert the corresponding stopper into a tube.

2 Remove breakthrough a nozzle from a tube. The tube after that itself departs back.


 INSTALLATION

The left and right nozzles differ from each other. Not to mix them, they have on the lower part marking of "R" and "L". If the nozzle is replaced, disconnect the shutter and rearrange it on a new nozzle.

3 Insert a nozzle into an opening in the shutter of a headlight and enter into a tube.
4 Take out a nozzle check, whether the tube on accession is fixed. If necessary put on it and record.
5 Insert a nozzle into the headlight shutter.


 CHECK

6 Include ignition, turn on the light and ask the assistant to turn on the windscreen washer switch.
7 The stream of water has to get to the center of a headlight of near and far light.

If the faroomyvatel has to join again, it is previously necessary to switch on and off ignition as differently the washer is blocked for 3 min.

8 If necessary adjust nozzles.