BMW 3 of the E46 series
+ BMW 3 Cars (E46)
+ Current leaving and service
+ Engine
+ Cooling systems, heating
+ Power supply systems, injection and release
+ Electric equipment of the engine
- RKPP and transmission line
Removal and RKPP installation
Removal and installation of the lever of gear shifting
Check of level and replacement of oil in RKPP
Removal and installation of the driveshaft
Differential and adjustment of gear wheels of the main transfer
Check level/replacement of oil in a reducer of the back bridge
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Schemes of electric equipment
|
Removal and installation of the lever of gear shifting Gear shifting drive
|
| 1 — the switching lever
2 — the basic plug
3 — a basic finger
4 — a support
5 — the gear shifting lever
7 — a support
8 — a cover | 9 — draft of switching
10 — a remote ring
11 — a lock washer
12 — the hinge of draft of switching
13 — a lock ring
14 — a washer
15 — a pin |
| |
| 1 Pull strongly the handle up, without rotating it thus. Remove a lever cover at the central console and remove it from the switching lever. The specified works are described in the Section Removal and installation of the central console, address to the Section Removal and installation of the central armrest.
| | Lifting operation and installations of the car on supports is connected with danger! Therefore before carrying out operation study Poddomkrachivaniye's Section and towage | 2 Lift and install the car on supports. Remove system of release and the thermofilter under the gear shifting lever, address to the Section Removal and installation of system of release.
|
3 Remove from the lower party of the car a lock bracket-1-. Remove a washer-2-. Take out sideways draft of switching-3-. |
|
4 Deliver from below on the switching lever a tsapfovy wrench, for example, to BMW 251110 and turn it on a corner 90 ° counterclockwise. After that wring out from the lever a spherical insert up. | 5 Disconnect a cover of the lever of switching at a body and take out it with the lever up. | |
| |
| 6 Grease spherical inserts of the lever with KLUBER POLZLUBE GLY greasing.
|
7 Install the switching lever with a spherical insert so that shooters on an insert showed in the direction of a longitudinal axis of the car (the shooter on an accompanying illustration). Pads of a spherical insert settle down across the car. |
|
8 Press from above an insert a screw-driver in the holder so that pads were distinctly recorded. |
|
9 Fix a cover. The arrow on a cover has to specify forward, in the direction of the movement. Insert an internal board of a cover via the lever, and external into cut of a body. | 10 Implant a finger of draft of switching into the lever, having put washers. Establish a lock bracket.
11 If necessary install the thermofilter and system of release, address to the Section Removal and installation of system of release.
12 Fix a switching lever cover on the central console. Put on the handle the lever and strongly press on it, address to the Section Removal and installation of the central armrest. |
|
|
|