BMW 3 of the E46 series
+ BMW 3 Cars (E46)
+ Current leaving and service
+ Engine
+ Cooling systems, heating
+ Power supply systems, injection and release
+ Electric equipment of the engine
+ RKPP and transmission line
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
- Body
General information and security measures
+ Leaving and repair of damages of a body
- External elements of a body
Removal and installation of a front bumper
Removal and installation/check of shock-absorbers of a bumper
Removal and installation of a rear bumper
Removal and installation of the back shock-absorber
Removal and installation of a cover of a fairing
Removal and installation of a forward wing
Removal and installation of a cowl
Adjustment of a cowl
Removal and installation of a trunk lid
Adjustment of a trunk lid
Removal and installation of the lock/cylinder of the lock of a trunk lid
Removal and installation of a gas-filled emphasis of a cowl/trunk lid
Replacement of moldings and emblem of model
Removal, installation and adjustment of a door
Removal and installation of facing of a door
Removal and installation of the lock of a door
Removal and installation of the cylinder of the lock
Removal and installation of the external handle of a door
Removal, installation and adjustment of a window
Removal and installation of the power window
Removal and installation of the electric motor of a window regulator
Removal and installation of a mirror of an external look / sound signal of a high-pitch tone
Removal and installation of glass of a mirror
Removal and installation of the case of a mirror of an exterior
+ Internal elements of a body
+ Onboard electric equipment
+ Schemes of electric equipment
|
Replacement of moldings and emblem of model
Replacement of moldings
Moldings are fixed on body elements by plastic brackets.
1 Separate a molding a hand or a wide plastic wedge.
2 As a rule, at office of moldings plastic fillers are removed together with brackets. Therefore at first remove from pins of the plug and insert them into openings of the corresponding elements of a body.
3 Correct the bent moldings before their installation into place.
4 Then a molding with brackets correct and fix according to openings. If necessary insert pins in blows of a palm.
Replacement of a firm emblem of model on a trunk lid
|
5 Separate a firm emblem of model from a body by means of thin a nylon thread (a fishing scaffold) and remove. For simplification grease a thread with detergent and fix wooden whetstones on both ends. Slightly heat an emblem the hair dryer. |
6 Remove the glue remains with alcohol or a cleaner, for example, "3M of Adhesive Cleaner".
Heat 7 New emblem the hair dryer to temperature about +50 °C, remove protective paper, correct and approximately on 10 with strongly press.
Replacement of an emblem of BMW
8 Carefully a screw-driver remove BMW emblem, for protection of a paint and varnish covering enclose a rag.
9 For the best skhvatyvaniye before installation under an emblem put sealing weight for a body. |
|