Removal and installation/check of shock-absorbers of a bumper
REMOVAL
1 Remove the forward shock-absorber.
2 Disconnect the shock-absorber-1-. For this purpose turn off nuts-3-.
On a place of nuts-3-there can be rivets. In this case they need to be zasverlit. Turn off nuts-2-and take out the shock-absorber. If there is a cable-4-connector, previously open it and turn off.
CHECK
3 Measure shock-absorber length from the center of a plastic insert to a basic surface. If the received value less than 127.5 ± 1 mm, replace the shock-absorber.
INSTALLATION
4 Insert into place the shock-absorber and fix its moment 50 N • m (a key on 13 mm) or 10 NChM (a key on 8 mm) or a priklepayta usual explosive rivets. 5 Fix a cable connector if he acted and record a cable. 6 Establish a front bumper.