BMW 3 of the E46 series

1 Lower glass completely down.
2 Remove facing of a door, uncover in the right part above, address to appropriate section.

The lateral safety cushion should not be removed.

3 Take out a small screw-driver two clips of-2 covers-1-from a forward end face of a door.

4 Uncover-1-, thus begin from below. Take out a cover at the door limiter.

5 Take out a cover above from a flat clip (poses. And on an illustration) also wring out up so that to provide access to screws of fastening of a mirror.

6 Rasstykuyte I will corrode protection against a jamming glass (it is white / a black cable).

7 Unscrew screws of fastening of a-2-sound signal of a high-pitch tone-1-and remove it.

8 Rasstykuyte I will corrode exterior mirrors.
9 Holding a mirror outside, turn out the screw-3-.
10 Remove a mirror, thus pass electric wires through a door.

11 Establish a mirror, thus pass electric wires through a door.
12 Holding a mirror outside, fix it the screw-3-.
13 Fix a sound signal of a high-pitch tone. Tighten screws-2-and-3 the moment of 6 N • m.
14 Join the socket of a mirror of an exterior and protection against a jamming glass.
15 Press protection against a jamming into a clip - And-.
16 Insert a cover of protection against a jamming on the limiter of a door and fix two clips at a door end face.
17 Establish facing of a door, address to appropriate section.