BMW 3 of the E46 series

since 1998 release

Repair and operation of the car



BMW 3 of the E46 series
+ BMW 3 Cars (E46)
+ Current leaving and service
+ Engine
+ Cooling systems, heating
+ Power supply systems, injection and release
+ Electric equipment of the engine
+ RKPP and transmission line
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
- Body
   General information and security measures
   + Leaving and repair of damages of a body
   - External elements of a body
      Removal and installation of a front bumper
      Removal and installation/check of shock-absorbers of a bumper
      Removal and installation of a rear bumper
      Removal and installation of the back shock-absorber
      Removal and installation of a cover of a fairing
      Removal and installation of a forward wing
      Removal and installation of a cowl
      Adjustment of a cowl
      Removal and installation of a trunk lid
      Adjustment of a trunk lid
      Removal and installation of the lock/cylinder of the lock of a trunk lid
      Removal and installation of a gas-filled emphasis of a cowl/trunk lid
      Replacement of moldings and emblem of model
      Removal, installation and adjustment of a door
      Removal and installation of facing of a door
      Removal and installation of the lock of a door
      Removal and installation of the cylinder of the lock
      Removal and installation of the external handle of a door
      Removal, installation and adjustment of a window
      Removal and installation of the power window
      Removal and installation of the electric motor of a window regulator
      Removal and installation of a mirror of an external look / sound signal of a high-pitch tone
      Removal and installation of glass of a mirror
      Removal and installation of the case of a mirror of an exterior
   + Internal elements of a body
+ Onboard electric equipment
+ Schemes of electric equipment



Removal and installation of a cowl

Cowl, loops, gas-filled shock-absorber and drive of a cowl

1 — a cowl
2 — lateral consolidation
3 — consolidations back
4 — the gas-filled shock-absorber
5 — a loop left
6 — the drive lever
7 — the cowl drive back
8 — a spherical support
9 — an emphasis
10 — a lock pin

11 — a clamp
12 — the cowl drive central
13 — a support for a hook
14 — the M6 x 35 screw
15 — the clown
16 — a nut with a washer
17 — the cowl lock
18 — the drive of a cowl lateral
19 — a cross-piece forward


 REMOVAL

1 Rasstykuyte socket of nozzles of windscreen washer.
2 Separate hose connection of nozzles of windscreen washer.

3 Mark the provision of a loop-1-on a cowl for what lead round a loop a felt-tip pen.

4 Prop up a cowl or ask the assistant to take.
5 Turn out a bolt-2-at the left and on the right, weaken a bolt-3-.
6 Disconnect on the left loop a cable of weight-4-.
7 Remove a cowl by means of the assistant.


 INSTALLATION

8 Establish a cowl by means of the assistant, screw bolts-2-, without tightening them.
9 Expose a cowl according to the put marking and tighten fastening bolts.
10 If the cowl was replaced on new, adjust it.