BMW 3 of the E46 series
+ BMW 3 Cars (E46)
+ Current leaving and service
+ Engine
+ Cooling systems, heating
- Power supply systems, injection and release
Security measures and rules of observance of purity during the work with fuel system
Removal and installation of the sensor of a reserve of fuel / fuel pump
Check of the sensor of a reserve of fuel
- Power supply system of petrol engines
Removal, installation and check of the relay of the fuel pump
Removal and installation of the fuel filter
Removal, installation and adjustment of the drive of a butterfly valve
Removal and installation of the air filter of the engine
+ System of injection of fuel of the petrol engine
+ Power supply system of diesel engines
+ System of production of the fulfilled gases
+ Electric equipment of the engine
+ RKPP and transmission line
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Schemes of electric equipment
|
Removal, installation and adjustment of the drive of a butterfly valve
|
| The drive of gas is very sensitive to excesses. Therefore at installation it is necessary to handle with it very with care. The excess can lead to break of a cable subsequently. Therefore the cables having excesses should not be put.
The cars having automatic adjustment of speed of the movement "Tempostat" for the lever of a butterfly valve have an additional drive of gas. If it is necessary, it is disconnected to similarly ordinary drive of gas.
The diesel engine 320d has no gas drive. The provision of a pedal of gas is transmitted to a control system through the pedal sensor. |
|
|
|
1 Models 316i, 318i: Unscrew screws of fastening-1-at an element of a butterfly valve and uncover-2-. |
|
2 Give gas on the lever of a butterfly valve (the shooter on an illustration) to unload draft of gas. |
3 Squeeze a plastic clip on levels-1-, take out from an opening of the lever of a butterfly valve and remove from draft-2-.
4 Take out draft through a groove on the lever.
|
5 Take out a cover with the adjusting screw-1-from the rubber plug-2-on a support back. Take out sideways the rubber plug from a support. |
|
|
|
|
|
6 Insert the rubber plug into a support.
7 Put on a plastic clip through draft.
8 Give a little gas on the lever of a butterfly valve. Insert a cable through a groove and record a plastic clip.
9 Check adjustment of the drive of gas, if necessary adjust.
10 Models 316i, 318i: Fix a cover on knot of a butterfly valve. |
|
|
|
|
11 The lever of a butterfly valve has to adjoin to an emphasis of idling and the drive of gas has to be slightly tense. If necessary turn the adjusting screw-1-on a support so that draft stretched.
12 After that screw the adjusting screw-1-on 1/4 turns. Now draft has a small side play. Having pulled for a draft cover, it is possible to define a side play. The side play should not exceed 3 mm then the lever of a butterfly valve has to start moving.
13 Ask the assistant to press a gas pedal completely. Thus the lever of a butterfly valve has to reach position of the maximum gas. Otherwise it is necessary to tighten draft of gas a little.
|
| HUNDRED are checked by the provision of full gas by connection of the diagnostic unit which checks a corner of opening of a butterfly valve through indications of a potentiometer of the gate. |
14 Cars with AT: Pass on the car and check operation of the device kik-Down. If AT at inclusion of full gas does not switch to low transfer, it is necessary to address on HUNDRED for carrying out adjustments of the drive of gas. |
|
|
|