|
|
BMW 3 of the E46 seriessince 1998 releaseRepair and operation of the car |
|
|
BMW 3 of the E46 series + BMW 3 Cars (E46) + Current leaving and service + Engine + Cooling systems, heating - Power supply systems, injection and release Security measures and rules of observance of purity during the work with fuel system Removal and installation of the sensor of a reserve of fuel / fuel pump Check of the sensor of a reserve of fuel - Power supply system of petrol engines Removal, installation and check of the relay of the fuel pump Removal and installation of the fuel filter Removal, installation and adjustment of the drive of a butterfly valve Removal and installation of the air filter of the engine + System of injection of fuel of the petrol engine + Power supply system of diesel engines + System of production of the fulfilled gases + Electric equipment of the engine + RKPP and transmission line + Automatic transmission + Coupling and power shafts + Brake system + Suspension bracket and steering + Body + Onboard electric equipment + Schemes of electric equipment |
Power supply system of petrol engines
1 Lift and install the car horizontally on supports. Remove the lower cover of a motive compartment, address to the Section Removal and installation of the lower cover of a motive compartment. 2 Install the selector in situation "P".
4 Wring out the lever of a box-3-forward in the provision of a parking. Thus pull a cable-4-in an opposite direction and again release it. 5 Tighten a nut-2 moment of 10 N • m, holding thus the tightening plug-1-for a hexagon. 6 Check operation of the selector. For this purpose include ignition. At the motionless car the selector can move from situation "P" or "N" if the brake pedal is at the same time pressed. 7 The engine can be started only in position of the selector "P" and "N". 8 The ignition key can be taken out only in position of the selector "P". 9 Otherwise it is necessary to address on HUNDRED. |
|